Tools Required:

• Drill with 8 mm bit
• T20 Driver Bit / Screwdriver
• Spirit Level

Parts Included:
The package includes all components required for installation:

• 1x Balance Wall Cabinet
• T20 Mounting Screws
• Wall Plugs
• Cardboard Mounting Template

Installation Steps:

1. Measure and Mark
Use the included Cardboard Template to mark the four mounting points on the wall. Use a spirit level to ensure the marks are straight and aligned.

Important: Before drilling, use a detector to check the wall for hidden pipes or electrical wiring.

2. Drill Holes

• For Masonry/Concrete Walls: Drill holes at the marked positions using an 8 mm drill bit.
• For Wooden Walls: Do not use the 8 mm bit. Instead, pre-drill 3 mm pilot holes for the Mounting Screws. Wall Plugs are not needed for wood.

Important: Always drill straight (perpendicular to the wall).

3. Insert Wall Plugs
Insert the provided 8 mm Wall Plugs into the drilled holes (Masonry/Concrete only).

4. Install Upper Screws
Insert the top two Mounting Screws into the wall (or Wall Plugs) using the T20 bit. Do not tighten fully. Leave a gap of approximately 20 mm between the screw head and the wall.

5. Hang the Cabinet
Lift the Balance Wall Cabinet and hang it onto the two top screws.

6. Secure the Cabinet
Insert the bottom two Mounting Screws through the cabinet holes and drive them fully into the wall. Finally, tighten the top two screws until the cabinet sits flush and secure against the wall.

Cleaning and Maintenance

• Wood: Treat with furniture wax oil as needed.
• Hemp Cords: These are durable. If replacement is ever needed, please contact us.

If you have questions about the installation, please contact us.